3
3
-
400, 600, 1000, 1500 grit sponge sanding pads, higher grit micro-
mesh pads are optional depending on the desired sheen of the
fingerboard;
-
a fret crowning file;
-
a small triangular file;
-
a bastard mill file;
-
a good wipe-on gel finish. Avoid stain and oil finishes and give
preference to hard finishes such as lacquer or urethane. Avoid
Minwax® (sorry).
A final word before you start- It is highly recommended that you read ALL
of the assembly instructions first, then go back and start assembly. Although
it may not make sense to you be sure to follow the instructions in precise
sequence or you may have to disassemble parts or even start over.
Also, be sure to read and understand the use and care of all tools and wear
the proper safety equipment including but not limited to safety glasses,
hearing protection and all guards that are part of the equipment used.
It is important to note that this is a fine project that takes time and very
precise measurement. Be sure to take your time on each step and ALWAYS
be safe using the tools during your woodworking projects. Also, be in the
right frame of mind where your mind is clear and not distracted. Stay
focused and you’ll be more likely to remain safe and end up with a nice
guitar.
Good Luck!
Содержание Cutaway
Страница 12: ...12 12 Marking and Scalloping a Tone Brace...