SKU 99925
For technical questions, please call 1-800-444-3353.
Page 8
tool
air
compressor
Quick
coupler
air hose
on reel
Filter
regulator with
pressure gauge
male
connector
male
connector
Valve
Quick
coupler
recommended air line components
oiler
operating instructions
read the entire important
saFetY inFormation
section at the beginning of this
manual including all text under
subheadings therein before set
up or use of this product.
to preVent
serious injurY
From accidental
operation:
turn the power switch of the
tool to its “oFF” position and
unplug the tool from its
electrical outlet before
performing any inspection,
maintenance, or cleaning
procedures.
Make sure the air tool’s throttle or
1.
switch is in the off position.
Connect the tool that will be used for
2.
the job to the airline.
Close the in-line safety valve be-
3.
tween the compressor and the tool.
Connect an air hose rated to the in-
4.
tended PSI that will be used with the
tool to the Air Connection. The air
hose must be long enough to reach
the work area with enough extra
length to allow free movement while
working.
Plug the Power Cord into a grounded
5.
120 V electrical outlet.
Move the Power Switch up to the ON
6.
position.
power
switch
(23)
pressure
regulator
(20)
tank
pressure
gauge
tool
pressure
gauge
safety
Valve
(22)
Quick
coupler
(25)
Allow the Air Compressor to build up
7.
pressure until it cycles off.
Adjust the air compressor’s Pressure
8.
Regulator (20) so that the air output
is enough to properly power the tool,
but the output will not exceed the
tool’s maximum air pressure at any
time. Turn the knob clockwise to
increase pressure and counter-clock-
wise to decrease pressure. Adjust
the pressure gradually, while check-
