www.U-LineService.com
8
03/2008
2275 Dual Zone WC Model
2. Lightly scruff sand the wood trim with 280 or finer grit
sandpaper.
3. Remove sanding dust with a clean, dry cloth.
4. The factory-applied seal is compatible with virtually all
finishes. A low odor, water clean up, quick-drying finish
such as Minwax
®
Polycrylic
®
Protective Finish is
recommended (Minwax
®
Polycrylic
®
is an ultra fast-
drying water-based finish). Apply a thin coat of a clear,
protective finish, following the container label
directions.
5. Lightly sand and reapply if desired.
6. Allow the final coat to dry for 24 hours before
reinstalling the trim to the cabinet interior components.
FRAME PREPARATION
IMPORTANT
The thickness of the wood overlay panel must be
3/4".
1. Use the following instructions to create or have a
wood overlay panel created for your Échelon Wine
Captain or Beverage Center model as shown in
Figure
13
.
2. Drill holes for pivot pins, upper door hinge and lower
door hinge as shown.
3. The overlay door panel must be installed in accordance
with the Installation Instructions starting on page 9.
Figure 13
9 Overlay Frame (2275ZWCOL Only)
9/32
Dim A: 23-3/4”
2275WCOL
2175WCOL2
2175BEVOL2
Dim A: 14-3/4”
2115WCOL2
See Detail C
3/4”
Detail C
Scale 2:1
Door bottom
Ø 3/8” x 1/4” deep
Chamfer 1/32” x 45°
Detail A
Scale 2:1
Door top
Ø 3/16” x 11/16” deep
9/32”
3/8”
See Detail A
29-3/4”
NOTE: Front view of
wood panel with
right-hand hinge shown
(mirror image
for left-hand hinge)
Section A-A
Scale 2:1
Typ 4 places
NOTE: Final component
is only a picture frame.
No panel inside of rails
and stiles.
Right-hand
isometric view
shown.
Opposite
for left-hand
A
A
Dim. A
3/4”
2-1/4”
ULIN_1024_A
