02/2005
9
www.U-LineService.com
75R, 75WC and 75BEV Models
CAUTION
To prevent permanent damage to the inner liner of the
Beverage Center, the wine rack wood trim MUST be
removed from the unit for staining and/or finishing.
Allow stain/finish to dry thoroughly (at least 24 hours per
coat) in accordance with the stain/finish manufacturer’s
instructions prior to re-installing the wood trim inside the
cabinet of the Beverage Center. Failure to do so may cause
the inner liner of the unit to have a permanent odor,
which is not covered by the warranty.
Adding a Final Finish Coat to Wood
Trim
(75BEV Beverage Center Units Only)
1. Remove each wine rack by
sliding it out and up. See
Figure 16
.
2. Remove and save screws
securing wood trim to the
racks.
3. Lightly scruff sand the
wood trim with 280 grit
3M Tri-M-Ite sandpaper.
4. Remove sanding dust with
a tack cloth.
5. Apply a thin coat of Minwax Polycrylic, following
container label for directions. Allow to dry 24 hours.
6. Lightly sand, tack and reapply 2 times, if desired.
7. Allow the final coat to dry for 24 hours.
8. Reinstall wood trim to wine racks using screws
removed in Step 2.
9. Reinstall wine racks in unit.
10. Go on to
5 Adjust Door
.
Staining Wood Trim a Different
Color
(75BEV Beverage Center Units Only)
1. Remove each wine rack by sliding it out and up. See
Figure 16
.
2. Remove and save screws securing wood trim to the
racks.
3. Apply Minwax Water-Based Wood Stain to wood with a
synthetic foam brush. Stain must penetrate
approximately 3 minutes. After this period, while stain
is still wet, take a stain-dampened rag and remove all
excess stain. Wipe in the direction of the grain with
medium pressure to achieve the desired stain color.
4. After 2 hours, repeat Step 3.
5. Allow stain to dry for a minimum of 3 hours before
finishing.
6. Sand the wood with very fine sandpaper to smooth the
surface from the staining process.
7. Remove sanding dust with a tack cloth.
8. Apply a thin coat of Minwax Polycrylic, following
container label for directions. Allow to dry 24 hours.
9. Lightly sand, tack and reapply 2 times, if desired.
10. Allow the final coat to dry for 24 hours.
11. Reinstall wood trim to wine racks using screws removed
in Step 2.
12. Reinstall wine racks in unit.
13. Go on to
5 Adjust Door
.
S
lide O
u
t
a
n
d Up
Figure 16
