PAGE 10 OF 30
0318 IH-7259
PROBLEM
CAUSES
RECOMMENDATIONS
The inflated material has an
inconsistent air-fill amount.
Material roll improperly loaded.
Faulty material.
Ambient temperature needs to be
reset.
Electrical or mechanical failure.
Material has been affected by
storage conditions.
Reload material roll – see Loading Material
Roll on page 4.
Load new material roll – see Loading Material
Roll on page 4.
Return material roll – contact Uline Customer
Service.
Unscrew top edge seal assembly and
reattach to recalibrate the temperature.
Contact Uline Customer Service.
Refer to storage conditions under Safety.
PROBLEMS WITH THE ROLL WINDING
PROBLEM
CAUSES
RECOMMENDATIONS
The roll winder will not wind
inflated material.
The winder is stopped.
The winder is not plugged in.
Obstruction blocking the winder or
the roll.
Electrical or mechanical failure.
Press the winder start button – see
Producing Air-Filled Material in Roll Winder
Mode on page 6.
Verify that the roll winder is plugged in to
the bottom of the machine.
Verify the roll can wind free of obstruction.
Contact Uline Customer Service.
The roll is a different
diameter than expected.
The diameter setting is set
incorrectly.
Material roll is empty.
Electrical or mechanical failure.
Verify diameter setting – see Producing
Air-Filled Material in Roll Winder Mode on
page 6.
Load a new roll as required – see Loading
Material Roll on page 4.
Contact Uline Customer Service.
TROUBLESHOOTING CONTINUED
π
CHICAGO • ATLANTA • DALLAS • LOS ANGELES • MINNEAPOLIS • NYC/PHILA • SEATTLE • MEXICO • CANADA
1-800-295-5510
uline.com
If the problem persists or the troubleshooting section does not resolve or
describe your problem, contact Uline Customer Service at 1-800-295-5510.
