PAGE 2 OF 9
0422 IH-9648
Figure 2
ASSEMBLY CONTINUED
Figure 3
3. Place tabletop/leg assembly on its side.
(See Figure 2)
4. Push tabletop/leg assembly through undershelf
collars to desired height. A rubber mallet may be
needed to move shelf along leg tubes. To ensure
exact height, mark desired height on each leg
assembly with magic marker or grease pencil.
(See Figure 2)
NOTE: Each leg assembly must be at the
same height or shelf collars could fail.
Recommended height from the floor to the top
of the undershelf is 10" and must be 6"
or higher to meet NSF standards.
NOTE: Optional casters add 3⁄" to height.
NOTE: Undershelf can only be secured to outer
leg tube.
5. Secure legs to undershelf with set screws using
5/32" Allen wrench. (See Figure 3)
NOTE: Do not overtighten screws.
6. Level table with the adjustable feet. Adjustable feet
allow approximately 1" of adjustment. (See Figure 4)
NOTE: To adjust height after assembly, lay
table on its side. Remove Phillips head bolts
and flange nuts from each leg and adjust legs
to preferred height. This will result in the inner
leg tube moving along the outer leg tube.
Re-secure bolts and flange nuts on each leg
using a Phillips screwdriver and 10 mm wrench.
Undershelf
Figure 4
