PAGE 5 OF 39
0920 IH-8184
ASSEMBLY CONTINUED
11. Remove stringer. Fasten back side of assembly to
workbench top with five 8-15 x 0.625" tapping screws
through exposed holes along inner/outer rails.
(See Figure 10) Replace stringer as in step 6.
12. Place control box at center of assembly against
inner/outer rails on the exposed side. Secure control
box to table top using Phillips head drill and two
10-12 x 2" tapping screws. (See Figure 11)
13. Connect one motor cable into end of control Box
slot marked "1" and second motor cable into slot
marked "2." Then connect other end of motor cables
to each adjustable height leg by inserting cable
into white cable slot. (See Figure 12)
14. Connect the power for the control box by inserting
power cord into slot designated as "AC."
(See Figure 13)
15. The inner/outer rails feature a cable management
tray. Tuck the loose cords into the cable
management tray to hide them. (See Figure 14)
16. Position mounting bracket for programmable handset
at the front edge of the table top in desired position.
Bracket should face upward. Secure to table top using
Phillips head drill and two 8-15 x 0.625" tapping screws.
(See Figure 15)
Figure 11
Figure 12
Figure 13
Figure 14
Figure 15
Figure 10
