PAGE 2 OF 9
0621 IH-7174
2. Peel off paper from the back of tape (not included).
Press dispenser firmly to wall and hold for at least 30
seconds to ensure tape has completely adhered to
wall.
3. Wait 24 hours before filling with soap to ensure that
the tape has completely adhered to wall.
MOUNTING WITH SCREWS AND ANCHORS
1. Hold dispenser against wall in desired location.
2. Open dispenser.
3. Using the back of
dispenser as a template,
mark top hole location on
wall. (See Figure 3)
4. For bottom hole, measure
and mark 5⁄" from top
hole as shown.
5. Set dispenser down and
drill 3/16" diameter holes
for anchors and screws
(included).
6. Place dispenser on screws
and slide down into place.
INSTALLING BATTERIES
1. Open dispenser and remove plastic fill cartridge by
pinching cartridge tabs in and pulling toward user.
2. Ensure dispenser is set to OFF. Front LED light will
be off.
3. Locate the battery compartment cover at top of
control box. Pinch in red tabs on each side of cover
and pull the cover up and forward away from wall.
4. Place six AA alkaline batteries (not included) in the
proper orientation. (See Figure 4)
5. Replace the battery compartment cover by gently
sliding front brackets in place and pushing down.
NOTE: When LED light frequently blinks red,
change the batteries.
INSTALLING CARTRIDGE
1. Open dispenser.
2. Slide cartridge into dispenser with pump facing
toward front and down, ensuring the tabs click into
place and the nozzle ring is fixed into the groove in
lower control box. (See Figure 5)
3. Close dispenser cover. LED indicator will blink green
one time.
INSTALLATION CONTINUED
Figure 4
Batteries
Figure 5
Tab Placement
Nozzle Ring
Figure 3
Top
Hole
5⁄"
