PAGE 2 OF 9
0521 IH-5334
Figure 5
Paper
Ramp
Entrance
Funnel
ASSEMBLY CONTINUED
11. Place paper ramp onto paper entrance funnel
and secure with 10-32 x 1/2" bolts (6), ensuring bolt
head is on the inside of the funnel. Secure with #10
locking washers (6) and 10-32 nuts (6) underneath
the paper ramp. (See Figure 5)
CAUTION! If the bolt head is not on the inside of
the funnel, paper can catch on the bolt shaft
and nut.
12. Rotate unit 180 degrees back to original position,
with paper exit shoot facing front.
13. Insert blue motor
connector plug into
the blue plug on top of
power box and give a
quarter twist to lock.
(See Figure 6)
14. Insert gray foot pedal
connector plug into the
gray plug on the bottom
of the power box and
give a quarter twist to
lock. (See Figure 6)
NOTE: Both plugs
will click when
locked in place.
Motor
Connector
Foot Pedal
Connector
Figure 6
1. Plug power cord into a standard 115V outlet.
2. Make sure power switch is turned off.
3. Pull spring-
loaded pin and
turn unit 180
degrees to make
paper cradle
easily accessible.
4. Load kraft paper
onto the paper
cradle with
the paper roll
unspooling from
the outside.
(See Figure 7)
5. Pull end of paper
up towards the
paper entrance
funnel and fold
paper into
itself in a rough
triangle shape.
(See Figure 8)
6. Insert paper
into the paper
entrance
funnel. Using
the threading
disk, turn knob
clockwise until
it catches the
paper and
feeds it through
the head and
out the exit shoot. (See Figure 9)
7. Rotate unit 180 degrees back to original position,
with the paper exit shoot facing front. Turn on with
power switch on the power box.
8. Press down on the foot pedal to eject paper from
the exit shoot.
NOTE: The machine will continue dispensing
paper until foot is let off the foot pedal.
9. Release foot pedal.
10. Grab the ejected paper and pull strongly in a
downward motion to tear paper from the machine.
OPERATION
Figure 7
Figure 9
Figure 8
Threading
Disk
Power Box
