PAGE 4 OF 14
0821 IH-1927
TROUBLESHOOTING CONTINUED
DRYER MAINTENANCE CODES
CODE
OPERATING ISSUE
RECOMMENDATIONS
RESULT
1 short / 1 long flash
Clogged pre-filter
Remove and clean pre-filter.
Dryer will continue
to run.
1 short / 2 long flash
Severely clogged
pre-filter
Remove and clean pre-filter.
Dryer will stop.
2 short / 1 long flash
In lockout mode
Remove obstruction or
adjust sensor range.
Dryer will stop until
obstruction cleared or
sensor range is adjusted.
MOTOR PROBLEM CODES
1 long / 3 short flash
Motor current
too high
Measure voltage across
terminal block. If voltage ok,
motor is pulling too much
current. Replace motor.
Dryer will stop.
1 long / 4 short flash
Motor curent
too low
Measure voltage across
terminal block. If voltage ok,
motor is pulling too little
current. Replace motor.
Dryer will stop.
HEATER PROBLEM CODES
2 long / 3 short flash
Shorted or incorrect
heater
Replace heating element.
Dryer will stop.
Flashing red LED light displays codes in the sensor behind air outlet.
Normal operation will be indicated by the red LED being on when not drying and off when hands are
under the sensor.
ADJUSTING THE HEAT OUTPUT, MOTOR SPEED AND SENSOR RANGE
CODES
The dryer is shipped with maximum heat and maximum
motor speed. To adjust, turn the corresponding knob
counterclockwise to reduce.
NOTE: Knobs are located behind the dryer
cover:
H = Heat
M = Motor
R = Range
• Heat
– Air temperature (turn off to reduce energy
costs). When heat is off, the dryer is the same as the
XleratorEco version dryer.
• Motor
– Air flow speed (lower to reduce energy costs).
• Range
– The distance the sensor under the dryer,
used to recognize hands, will work.
NOTE: Eco® models have no heating element
and are set with heat at minimum.
1-800-295-5510
uline.com
