PAGE 2 OF 14
0821 IH-1927
INSTALLATION CONTINUED
MAINTENANCE
Figure 2
OUTSIDE
Using a soft cloth or sponge and mild soap or detergent,
gently wash the cover (including air inlet holes) with
lukewarm water to loosen dirt and grime.
INSIDE
CAUTION! Shut off power to the dryer at the
service connection. Cleaning should be
performed by qualified service personnel.
NOTE: With normal use, the dryer will require
cleaning once a year. Heavier usage requires
more frequent cleaning. Lint on the air inlet or
other internal parts of dryer will reduce efficiency
and shorten the life of the working parts.
1. Using the tamperproof wrench provided, remove
the cover by unscrewing the two tamper-proof bolts
from the side of the cover.
2. Use a small, soft brush to gently clean all parts.
5. Attach base plate at the four corners to smooth wall
(remove control assembly to access the right side
mounting hole). For most secure installation, use two
additional mounting holes. (See Figure 2)
6. Identify the voltage of your dryer from the rating
sticker of the unit. Then connect to a dedicated
branch circuit not exceeding 20 Amp.
7. Secure electrical wiring to terminals as indicated
by the schematic affixed to blower housing. An
identified ground connection point is supplied on
the base plate for the equipment ground wire.
8. Carefully replace cover using the two screws
removed in Step 2. Restore power and test for proper
operation. In multiple installations, make sure the
serial number marked on the inside matches the
cover number.
9. Apply a bead of silicone sealant around the
outside of the cover at the wall to protect the dryer
from internal corrosion caused by wash water and
cleaning solutions.
WARNING! To reduce the risk of fire, electric
shock or injury, use dryer only in the manner
intended by the manufacturer.
Before servicing or cleaning unit, switch off
power at service panel and lock the service
disconnecting means to prevent power from
being switched on accidentally.
When the service disconnecting means
cannot be locked, securely fasten a prominent
warning device, such as a tag, to the service
panel.
SIDE VIEW
6⁄"
10⁄"
8⁄"
9⁄"
9⁄"
2⁄"
5⁄"
5⁄"
4⁄"
12⁄"
WA
LL
FRONT VIEW FACING WALL
4⁄"
to center of
air outlet
Location of additional
mounting holes for
more secure installation
Electrical inlets
(2) 7/8" Dia. Holes
For In-Wall Connection
(10) Mounting Holes
5/16" Dia.
11⁄"
8⁄"
8⁄"
4⁄"
4⁄"
4⁄"
12⁄"
6⁄"
Surface Mounted
Electrical Entrance
7/8" Dia. Hole
