PAGE 5 OF 7
0421 IH-1630
BRUSH AND PAD DRIVER INSTALLATION
CAUTION: Disconnect the power cord from the
electrical outlet before installing a brush or pad
driver.
To install a brush or pad driver, leave the handle in the
upright position and tip the machine backwards so it rests
on its wheels and upper handle section. (See Figure 4) The
brush and pad driver both attach in the same manner:
align the cutouts on the inner ring of the brush or pad
driver with the tabs on the inside of the ring of the drive
hub. (See Figure 5) Push the brush or pad driver firmly in
position, then turn it counterclockwise until it locks into
place.
To remove, turn the brush or pad driver clockwise until
it stops, then lift it off. Note: Always remove the brush
or pad driver when the
machine is not in use.
CAUTION:
Disconnect the
power cord from
the electrical
outlet before
installing a brush
or pad driver.
HANDLE ADJUSTMENT
The handle can be adjusted to any desired work
position by simply pushing up on the handle lock. (See
Figure 6) Move the handle to the desired position, then
firmly push down on the handle lock which will lock the
handle in position.
HANDLE CAM LOCK ADJUSTMENT
With the handle cam lock in the “up” position
(unlocked), tighten the adjusting nuts until there is a
slight drag when the handle is raised or lowered. The
tube should be locked securely when the handle lock is
pressed downward. (See Figure 7)
Figure 4
ON
OFF
Figure 6
Unlock
Lock
Figure 5
Adjusting
Nuts
Figure 7
IMPORTANT SAFEGUARDS CONTINUED
