PAGE 3 OF 7
0421 IH-1630
DANGER
Improper connection of an equipment-grounding
conductor can result in risk of electric shock. Check
with a qualified electrician or service person if you are
in doubt as to whether the outlet is properly grounded.
Do not modify the plug provided with the appliance. If
it will not fit the outlet, have proper outlet installed by a
qualified technician.
This appliance is for use on a nominal 120 volt circuit
and has a grounding plug that looks like the plug
illustrated in Figure 1. A temporary adapter which looks
like the adapter illustrated in Figure 2 may be used to
connect this plug to a two-pole receptacle, as shown,
if a properly grounded outlet is not available. The
temporary adapter should be used only until a properly
grounded outlet, Figure 1, can be installed by a
qualified electrician. The green colored rigid ear, lug, or
the like extending from the adapter must be connected
to a permanent ground such as a properly grounded
outlet box cover. Whenever the adapter is used, it must
be held in place by a metal screw.
For floor finishing machines rated 150–250 volts:
If the machine is provided with an attachment plug
cap as shown in Figure 3, it is intended for use on a 240
volt (nominal) circuit. No adapter is available for this
application.
NOTE: In Canada, the use of a temporary
adapter is not permitted by the Canadian
Electrical Code.
OPERATION/ACCESSORIES
CHOOSING THE RIGHT BRUSH AND DRIVE BLOCK
Your floor machine is packed complete and ready for
use after you install a brush or drive block. (Brushes and
pads are not provided with the unit but are available at
an additional cost.)
Your floor machine is designed to be used for many
different floor care applications. Make sure you use
the correct brush or pad for the type of job you want to
perform. (Accessories are available from the dealer from
whom the floor machine was purchased.)
When ordering brushes or drive blocks, refer to this
chart and specify correct brush or block diameter when
ordering.
MACHINE SIZE
BRUSH DIAMETER
BLOCK DIAMETER
17"
17"
15"
Figure 1
GROUNDED OUTLET BOX
Plug Grounding Pin
Grounding Tab
Metal Screw
Adapter
Figure 2
Plug Grounding Pin
Figure 3
IMPORTANT SAFEGUARDS CONTINUED
