PAGE 1 OF 6
0823 IH-10899
1-800-295-5510
uline.com
H-10899
BUNN
®
AUTOMATIC
COFFEE MAKER
SAFETY
CAUTION! The brewer must be disconnected
from the power source until specified in Setup.
ELECTRICAL REQUIREMENTS
The brewer has an attached cordset and requires
two-wire grounded service rated 120 volts AC, 15 amp,
single phase, 60 Hz.
PLUMBING REQUIREMENTS
• Brewer must be connected to a cold water system
with operating pressure between 20-90 psi
(138-620 kPa) from a 1/2" or larger supply line.
• A shut-off valve should be installed in the line
before the brewer.
• Use a regulator if pressure is greater than 90 psi
(620 kPa) to reduce to 50 psi (345 kPa).
• 1/4" Copper tubing is recommended for
installations of less than 25 feet and 3/8" for more
than 25 feet from the water supply line.
• Fill water tank before turning on thermostat or
connecting appliance to power source.
• Use only on a properly protected circuit capable
of the rated load.
• Electrically ground the chassis.
• Follow national/local electrical codes.
• Do not use near combustibles.
• Failure to comply risks equipment damage,
fire or shock hazard.
• Read all instructions before using this product.
• This appliance is heated whenever connected to
a power source.
• To reduce the risk of electric shock, do not remove
or open cover. No user-serviceable parts inside.
Authorized service personnel only. Disconnect
power before servicing.
Para Español, vea páginas 3-4.
Pour le français, consulter les pages 5-6.
SETUP
1. Insert an empty funnel into rails. (See Figure 1)
2. Place an empty dispenser under funnel.
3. Turn heater switch to
OFF
position.
NOTE: Heater switch is on the rear of
the brewer.
4. Connect brewer to power source and turn the
on/lower switch to
ON
position.
Figure 1
Funnel
