USER GUIDE
Side by Side Installation 1
u-line.com
SAFETY •
INSTALLATION & INTEGRATION
• OPERATING INSTRUCTIONS • MAINTENANCE • SERVICE
Side by Side Installation
Two units may be installed side by side.
Cut-out width for a side-by-side installation is the cut out
dimension of a single unit times two.
No trim kit is required. However, 1/4" (6 mm) space needs
to be maintained between the units to ensure
unobstructed door swing.
Units must operate from separate, properly grounded
electrical receptacles placed according to each unit’s
electrical specifications requirements.
Side-by-Side Installation with Bracket
1. Slide both units out so screw on top of units are easily
accessible.
2. Remove screws as shown below.
3. Place bracket over holes and attach to unit with two
screws removed in step 2 using a slotted screwdriver.
Tighten screws fully.
4. Gently push units into position. Be careful not to
entangle the electrical cord, or water line if applicable.
5. Recheck the leveling, from front to back and side to
side. Make any necessary adjustments. The unit’s top
surface should be approximately 1/8" (3 mm) below
the counter top.
