u-blox C099-F9P, Руководство пользователя

Страница: 7 / 48

C099-F9P - User Guide
UBX-18055649 - R02 C099-F9P quick start Page 7 of 48
2 C099-F9P quick start
This section provides some short steps to enable ZED-F9P operation before exploring the more
complex configurations described later.
Figure 2. Basic C099-F9P overview with details needed for quick start
2.1 Starting up
•
Connect the supplied multi-band GNSS antenna to the ZED-RF SMA connector. Ensure good
signal reception.
•
Connect the USB to a Windows 10 PC; this will power the board. The driver will be installed
automatically from Windows Update when you connect the board for the first time.
•
Start u-center and connect to the COM port identified as“C099 application board, ZED-F9P”
using Device Manager. Set the baud rate to 460’800 baud. See section 4.3.1 for detailed
instructions.
•
If everything is correctly installed, the receiver should begin operation in its default state. The
Figure 4 below shows a typical u-center view with active satellite signal levels etc. The TP LED
on the C099-F9P board will blink in blue color.
To operate the ZED-F9P in RTK more, the GNSS antenna must be placed in an open environment and
the unit must be connected to a RTK correction service. Where available, the evaluation kit comes
with a free trial of the SmartNet correction service. Consult the leaflet included with the kit for
information on how to register for the service and how to obtain mount point and user connection
details before moving to the next steps.
RTK corrections can be applied using a u-center built-in NTRIP client. To use the C099-F9P board with
a correction service follow these next steps:
•
In u-center, click on the Receiver Menu item
•
Select “NTRIP Client…”
•
Fill in the settings for the NTRIP caster, username and password
•
Click “Update source table” and select the recommended NTRIP mount point
USB port ZED-F9P LEDs ZED-F9P module ZED-RF connector