Tytan DS 512, Руководство по установке

Страница: 9 / 21

Digital Systems
9
ALARM The DS512 in mode 3 and 4 (operating as VSS) has detected alarm
condition and is alarming.
ALARM_OEM The DS512 has detected, that OEM CAN VSS has been triggered
(modes 2,3,4) .
ALARM_PAGER The DS512 has detected, that monitored analogue VSS has been
triggered and is alarming (mode 1 - analogue Pager) .
LOCK_STATE VSS system is armed / vehicle is locked.
LOCK_woTRUNK VSS system is armed without trunk, rear door, additional sensor - the
3rd button on remote has been used.
DOOR (...) Door is opened.
TRUNK Trunk is opened.
BONNET (CAN) Bonnet is opened - signal from OEM switch read from CAN-bus.
BONNET (switch) Bonnet is opened - analogue signal read via gray wire(pin4) in modes (3
and 4).
DOOR/TRUNK/BONNET The lamp signals if any input is triggered. If the lamp is on, the door
status in SMS is sent as opened, In mode 1 (analogue pager) that lamp
shows the status of monitored VSS inputs.
GLOBAL_IGNITION The result of ignition signal - the sum of signals from CAN-bus and
analogue signal (orange wire).
IGNITION (CAN) Ignition switch signal read from CAN-bus.
ACC (CAN) ACC (ignition switch in accessory position) signal read from CAN-bus.
HZD_LEFT, HZD_RIGHT,
HAZARD LIGHTS Direction indicators and hazard lights status.
STATUS1- Status of additional analogue ground signal connected to blue wire (pin
4), necessary for CAN-bus connections on some vehicles (e.g. Renault
Clio).
Status of additional positive analogue signal connected to orange wire
(pin 3), necessary for CAN-bus connections on some vehicles (e.g.
Subaru Forester).
SEND LOCK,
SEND UNLOCK,
SEND UNLOCKTRUNK
SEND HAZARD LIGHTS
SEND CLOSE WIN The lamps show that DS512 is sending CAN-bus commands to the
vehicle, that control the vehicle circuits (power door locks, hazard lights,
power windows).
PA button / ultrasonic The lamp show that the PA button is pressed or the additional sensor
input is triggered.
LED The lamp repeats the LED state.
ALARM STATE Device is in alarm state - it is alarming or there was an alarm since last
arming
EXT_SENSOR_INP Additional sensor input is active
EXT_SENSOR2_PRE The lamp shows that additional sensor No2 Prealarm input was
triggered.
EXT_SENSOR2 The lamp shows that additional sensor No2 Alarm input was triggered.
Columns 6-7 show the status of device analogue inputs / outputs.
Lamp Description
OUT_IMMORELAY The lamp shows that the immobilisation relay output is active -
connected to ground.
OUT_HAZARD The lamp shows that the hazard lights control output is active -
connected to ground
OUT_SIREN The lamp shows that the siren control output is active - connected to
ground
OUT_LED The lamp shows that the LED control output is active - connected to
ground
AI0 (pin9),
DI0 (pin6), DI2 (pin4),
DI1 (pin3), DI5 (pin5), The lamps show the physical state at the given input. The lamp lights up
if the voltage at the input is positive. That is why the PA button and
STATUS1- inputs, which do have internal pull-up are displayed as
active.