15
XON/XOFF protocol
2) Parallel port:
36 pin Centronics connector. 8 bits parallel, supports BUSY/nAck
protocol
3) USB port:
USB1.0
4) Ethernet port:
Transmission speed: 10M (Max)
Communication protocol: TCP/IP protocol
Connector: 10 Base-T RJ-45 connector
5) Cash drawer port:
DC 24V/1A, 6 wires RJ-11 socket
1.6)
Electrical Characteristics
1) Supply voltage:
Input: AC 110V/220V, 50~60Hz
Output: DC 24V/2.5A
1.7)
Reliability
MCBF: 10,000,000 lines
(This is an average failure interval based on failures relating to
wear out and random failures up to the life of 15 million lines.)
1.8) Environmental Conditions
1) Temperature: Operating: 0 to 50C (41 to 113F)
Storage: -10 to 60C (14 to 122F) (except paper)
2) Humidity: Operating: 10 to 80% RH
Storage: 10 to 90% RH (except for paper)
NOTE: If the printer is not used for a long time with paper installed, some part of the printing may be light
due to the deformation of the paper. If the printer is not used for a long time with paper installed, be
sure to feed paper approximately 30 mm before printing
.
3) Acoustic noise (Operating): When using auto cutter Approximately 50 dB
(Bystander position) When not using auto cutter: Approximately 40 dB
(Bystander position)
1.9) Installation
The PRP-076 series printer must be installed horizontally. (Vibration during paper cutting and using a drawer
should be considered. Take measures to prevent the printer from moving. Affixing tapes are provided as an
option.) An optional hanging bracket can attach the printer to a wall. (Following the procedures describes in the
installation manual, install the wall mount and change the location of the paper roll near-end sensor, then install
