11
2.4
Noise emission values
The measurements were made in accordance to the norms EN ISO 3744, EN ISO 11201 and EN
12418. Therefore it was used a standard saw blade Type W3 0700 mm (not a silent blade).
Parameter
Value
continuous sound
pressure level
at work LoA
91 dB (A)
Sound power level LwA
92 dB (A)
Sound power level at the
ear of user
106 dB (A)
2.5 Vibration at the grab handle
When cutting the oscillation total value is under 2,5 m/s
2
.
3. Assembly and initial preparation for operation
3.1
Assembly tools
- Combination wrench size 13/46
3.2
Set up and assembly
- Put the saw on a clean and capable of bearing ground
- Remove the packing
3.3
Installation of the saw blade (or checking the installation)
- Loose the clamp handle (item 7).
- Lift up the saw head and tighten the clamping lever (item 7).
- Remove the side protecting sheet metal.
- Remove the flange nut (left-hand thread) and thrust washer.
ATTENTION! When installing the saw blade, observe the following:
- All receptacle surfaces must be clean.
- Rotation direction arrow on the saw blade must match the one on the hood.
- Use only diamond saw blades provided by the manufacturer.
- lnstall thrust washer and flange nut. (Combination wrench size 13/46).
- Mount the side protecting sheet metal.
3.4
Saw preparations
- Fill the tub with water until the pump is submerged.
- Open the water valve.
- Plug the supply line cable (400 V, 32 A) into the connector plug (item 11)
.
- Check protective equipment (see 2.2).
