TYROLIT Hydrostress HBH534 series, Инструкция по безопасности и эксплуатации

Страница: 11 / 38

Safety & Operator Manual Hydraulic Hand Saw HBH534***
11 10984829 EN / 28.08.2007
3 Start-up
3.1 Putting into operation
Each time that the hydraulic hand saw is put into operation it must be checked to ensure
that it is free of defects. Putting into operation of the individual system parts (machines
and components) is described in the corresponding Operating Instructions or instruction
leaflets.
4 Operation
4.1 General
Before proceeding read Chapter 2 “Safety instructions”, 2-1 in this Safety Manual. Be
sure also to take note of all the danger information given here and follow the instructions
on how to avoid physical injury and damage to property.
4.1.1 Safety
instructions
It is essential to observe the following safety instructions, in particular in relation to the
operation of the hydraulic hand saw.
4.1.2 Personnel qualifications
The hydraulic hand saw should not be operated by unauthorised persons.
Personnel are only authorised where they meet the following requirements:
•
Have successfully completed user training at TYROLIT Hydrostress AG or
corresponding technical courses at regional professional associations and
federations.
•
The Safety instructions in Chapter 2 must have been read and understood.
•
Are familiar with all the general rules of architecture
4.2 Safety-related operator’s controls
4.2.1 Blade
guard
The blade guard is a safety device. It provides protection from accidental contact with the
cutting tool and from flying parts and at the same time acts as a spray guard. Working
without the blade guard is prohibited.
4.3 Operation
In order to guarantee that all work is carried out in complete safety, it is essential to
perform the activities described in this Safety Manual.