TYROLIT Hydrostress HBH534 series, Инструкция по безопасности и эксплуатации

Страница: 8 / 38

Safety & Operator Manual Hydraulic Hand Saw HBH534***
8 10984829 EN / 28.08.2007
2.4 General safety rules
2.4.1 Statutory
provisions
The generally applicable national and local safety and accident prevention provisions and
the supplementary operator regulations must be followed and complied with.
2.4.2 Warranty
TYROLIT warrants that the hydraulic hand saw will operate correctly and safely on
condition that all the directions, working instructions and maintenance instructions
contained in this Safety Manual and in the Operating Instructions are strictly followed and
observed.
TYROLIT will not entertain claims for liabilities, any damages or warranty Claims for
damage that has arisen as a result of improper or inappropriate handling.
2.4.3 Inspection and maintenance obligation
The operator is under an obligation to only use the hydraulic hand saw when in perfect
and undamaged condition. The maintenance intervals shown in the Safety Manual must
be strictly observed and documented in this hand book. Malfunctions and mechanical
damage must be rectified without delay. Prior every use inspect the following:
•
Shaft arm for fatigue or damage
•
Shaft / spindle for fatigue or damage
•
Inner and outer flange for fatigue or damage (replace flanges when worn)
•
Diamond saw blade for any faulty or damaged segment weld, mounting screws
and bolt for any damage.
2.4.4 Spare
parts
Only original spare parts should be used. Otherwise damage may be caused to the
machine or damage to other property and personal injury may result.
2.4.5 Modifications
No technical alterations should be made independently to the equipment and installation
components in the form of additions or conversions without the written consent of
TYROLIT . This concerns all additions and conversions that are not provided for by the
system design.
2.4.6 Safety instructions in the individual chapters
The chapters of this Safety Manual and of the Operating Instructions contain additional
safety instructions. These make reference to specific potential dangers (residual
dangers). The instructions must be followed closely and require that the actions or
sequences of actions described are taken.
2.4.7 Correct
application
The hydraulic hand saw is designed and built for the following application:
•
Cutting of concrete (including reinforced) and natural stone.
•
Cutting of parting cuts, flush cuts, cross-cuts and joints.