TYROLIT Hydrostress HBE 350, Руководство по эксплуатации

Страница: 13 / 24

WARNING: Always use the PRCD (GFCI) when operating with water
WARNING: Never allow water to enter the motor. It could lead to an
electric shock.
WARNING: Check all connections of the water feed system to ensure
there are no leaks. Inspect hoses and other critical parts which
could deteriorate.
WARNING: The maximum water pressure should not exceed 70 psi (4
Closed
Open
Water Feed Valve
bar).
Use a water collector with a wet vacuum to collect cooling water if nearby objects could be damaged by water.
The water feed system is built into the machine. To connect with the water supply, first pull the quick-release
collar to remove the female side of the water coupling. Then unscrew the nut and engage the coupling to the
water hose. Now reconnect the water coupling to the male water feed valve. Press it until it clicks.
The water flow is controlled by the water feed valve. The water to the blade may be finely adjusted to the
required amount and no more.
NOTE: Contaminants in the water supply can easily plug up the fine water nozzles in the blade guard.
Ensure that the supply water is clean. If you find that there is no water flow to the blade, then clean out
the water feed system on the machine.
GUIDE ROLLER ASSEMBLY
The guide rollers make it easier to keep the blade plane perpendicular to
the workpiece. To install, slacken the butterfly bolt slightly and engage the
four claws with the four eyelets on the bottom of the motor housing, then
tighten the butterfly bolt. Note that roller assembly is offset to one side to
avoid contacting the blade, so it may only be installed in one orientation.
If it is not needed, the guide roller assembly may be removed and set
aside.
OVERLOAD PROTECTION, OVERHEAT PROTECTION
Overload & Load Warning Lamp
When full load is reached, the load warning lamp will flash red. If full load
is exceeded and sustained for too long, the motor will shut down and the
load warning lamp will glow solid red. In this case, the motor must be first
shut off and then restarted. When this happens, the motor will very likely
be near overheating, so it is also a good idea to run the motor at no load
for a few minutes to cool it before continuing.
Overheat Thermal Protection
Butterfly Bolt
Load Warning Lamp
If the temperature of the motor gets too high, the thermal protection will shut the motor down. The switch
must be first shut off and then restarted. When this happens, do not immediately start cutting after restarting
13