TYROLIT Hydrostress AGE125, Руководство по эксплуатации

Страница: 23 / 178

TYROLIT
AGE125 23
Instructions for use
WARNING!
Before carrying out any work on the angle
grinder, always pull out the mains plug.
Before switching on the power tool
Unpack the angle grinder and check that
there are no missing or damaged parts.
Attach the guard
WARNING!
When using the angle grinder for roughing or
cutting, never work without the guard.
A special cutting guard must be used for cutting.

Pull out the mains plug.

Attach the guard (1.). Lugs on the guard
hood must be located in the flange
recesses (2.).

Turn guard hood clockwise.
Rotation is possible in one direction only!

Remove in reverse order.
Attach the handle
NOTE
It is not permitted to operate the electric
power tool without the handle.
Attaching/changing the tool

Pull out the mains plug.
Attach the grinding wheel

Press and hold down the spindle lock (1.).

Using the face spanner, loosen the
clamping nut on the spindle in an anti-
clockwise direction and remove (2.).

Insert the grinding wheel in the correct
position.

Screw the clamping nut with flange face
up, onto the spindle.

Press and hold down the spindle lock.

Tighten the clamping nut with the pin
wrench or stop key.

Carry out a test run to check that the tool
is clamped in the centre.
Test run

Insert the mains plug into the socket.

Switch on the angle grinder with the
switch (without engaging it) and run the
angle grinder for approx. 30 seconds.
Check for imbalances and vibrations.

Switch off the angle grinder.