typical TW1-571, Инструкция по эксплуатации

Страница: 32 / 58

Installation and commissioning
8
.09.02
On machines with Typical-PicoDrive and control unit P44 PD-L
● Switch on the machine.
● Call up the parameter input by pressing the "scroll" key.
● To switch the function keys to input (LED in the
TE
key lights up), press the
TE key.
● By pressing the corresponding
+ /- keys, select parameter "798" and service level C,
see Chapter
Selecting the User Level
in the separate Control Panel Instruction Manual.
● Select parameter "799" by pressing the corresponding
+ /- keys.
● Check whether the value on the
571
and
591
is set at "4" and on the
574
at "6" and alter if
necessary.
● Switch the machine off and then on again.
● Select parameter "800" by pressing the corresponding
+ /- keys.
● Check whether the value is set at "1" (balance wheel turns towards the operator) and alter
if necessary.
● Select parameter "802" by pressing the corresponding
+ /- keys.
● Check whether the value is set at "0" on the
571 and 591 (= no gear reduction) and at "1"
on the
574
(= gear reduction), alter if necessary.
● By pressing the corresponding
+ /- key,
select parameter "700"
● Sew a stitch by operating the pedal.
● Turn the balance wheel in the sewing direction until the descending needle is level with
the top edge of the needle plate.
● Then check the parameter values listed in the parameter list (see Chapter
10.07 Parameter Settings)
and adjust them if necessary.
● Conclude the adjustment of the sewing motor by pressing the
TE/Speed key.
30