Tynetec Reach, Руководство по установке пользователя

Страница: 19 / 28

‐ 19 ‐
2.3.1 LOAD DEFAULTS & PARAMETER CHECK
Load Defaults – clears all programming, the personal recipient message and all radio devices from the
Reach memory. Enter #000; the unit will announce “ Load Defaults ” then press # .
Load System Defaults – clears all programming from the Reach memory. Enter #001; the unit will
announce “ Load System Defaults ” then press # .
Load Radio Defaults – clears all radio devices from the Reach memory. Enter #002; the unit will
announce “ Load Radio Defaults ” then press # .
Check Parameters – confirms the unit ID, telephone numbers, protocol type, the pendant ID (plus any
other radio devices learned into the unit) and the software revision. Enter #003 and the unit will
announce the above settings.
2.3.2 AUDIO SETTINGS
GSM Mode – this mode should only be enabled if the Reach is being connected via the Mobile network
using a GSM unit rather than a conventional PSTN land line. This prevents a telephone line fault being
detected when the GSM unit goes into low power mode during a mains failure.
Enter #004 ; press 0 to Disable or 1 to Enable followed by # .
Siren Volume – the volume of all alarm messages and dial ‐ out tones can be set between 0 (off) and 5
(highest). Enter #005 ; the unit will announce “ Siren Volume ”, press 0 to 5 followed by # .
Audio Volume – the speech volume to/from the control centre can be set between 0 (off) and 5
(highest). Enter #006 ; the unit will announce “ Audio Volume ”, press 0 to 5 followed by # .
Ring Volume – the volume of the internally generated ring tone (this is only used if there is no
telephone connected to the TEL socket) can be set between 0 (off) and 5 (highest). Enter #007 ; the unit
will announce “ Ring Volume ”, press 0 to 5 followed by # .
Audio Mode – allows the control centres method of switching the speech to be set. Simplex means the
speech direction is manually switched whereas Half Duplex is voice switched. Note; always check with
the control centre which method they prefer to use. Enter #008 ; the unit will announce “ Audio Mode ”,
press 0 for Simplex or 1 for Half Duplex followed by # .
Mains Fail Alert – allows the audible “ Please Check Your Mains Supply ” message to be turned on/off.
A mains failure is reported to the control centre after a random delay between 1 and 4 hours.
Enter #009 ; the unit will announce “ Mains Disconnection Alert ”, press 0 to Disable or 1 to Enable
followed by # .
Assurance Tone – allows the audible “ Please Wait – Dialling for Assistance ” message and dial ‐ out
tones to be turned on/off. Enter #010 ; the unit will announce “ Assurance Tone ”, press 0 to Disable or 1
to Enable followed by # .
Telephone Line Alert – allows the audible “ Please Check Telephone Line ” message to be turned on/off.
Enter #011 ; the unit will announce “ Telephone Line Disconnection Alert ”, press 0 to Disable or 1 to
Enable followed by # .