Tynetec Altec 169MHz, Руководство по установке

Страница: 3 / 9

Doc No. FM0600 issue E Page 3
Door Frame
Door
2. HOW TO INSTALL A BED SENSOR
The Bed Sensor must be placed between the bed base and the mattress.
Check the base is in reasonable condition with a flat firm surface
to lie the sensor on.
The sensor should be placed across the width of the bed at a point
where the hips of the person will be when lying down.
The sensor should be placed so the connecting cable exits
safely without causing a trip hazard.
Plug the lead into the Sensor Controller.
Bed Sensor with 2m Lead: Tynetec P/No: ZCS844
Dimensions: 650mm x 130mm x 10mm (LxWxD)
RJ45 Double Adapter (used to connect 2 bed sensors): Tynetec P/No. P10285
3. HOW TO INSTALL A CHAIR SENSOR
The Chair Sensor must be placed between the seat base and the cushion.
Check the base is in reasonable condition with a flat firm surface
to lie the sensor on.
The sensor should be placed across the width of the chair at a point
where the person will be sitting.
The sensor should be placed so the connecting cable exits
safely without causing a trip hazard.
Plug the lead into the Sensor Controller.
Chair Sensor with 2m Lead: Tynetec P/No. ZCS859
Dimensions: 325mm x 130mm x 10mm (LxWxD)
RJ45 Double Adapter (used to connect 2 chair sensors): Tynetec P/No. P10285
4. HOW TO INSTALL A PRESSURE MAT
The Pressure Mat must be placed under the carpet or rug
alongside the bed so it will be stood on when
the person gets out of bed.
The mat should be placed so the connecting cable exits
safely without causing a trip hazard.
Plug the lead into the Sensor Controller.
Pressure Mat with 2m Lead: Tynetec P/No. ZCS857
Dimensions: 520mm x 400mm x 6mm (LxWxD)
RJ45 Double Adapter (used to connect 2 pressure mats): Tynetec P/No. P10285
5. HOW TO INSTALL DOOR CONTACTS
The Door Contacts should be installed by a
competent person on the frame
of the door being monitored.
Fix the contact (part with wire connected)
to the door frame. Clip the cable to the
door frame and route safely without
causing a trip hazard.
Fix the magnet to the door. There should
be no more than 10mm between the Magnet
2 parts when the door is closed.
Plug the lead into the Sensor Controller.
Door Contact with 2m Lead: Tynetec P/No: ZCS854
RJ45 Double Adapter (used to connect 2 door contacts): Tynetec P/No. P10285
Cable to Sensor Controller