LED cube style light installation (light not included).
a. Remove outer covers from back of Bumper, (Fig 12).
b. Attach lights to mounting tabs on back of each end of the
Bumper, (Fig 12).
Snap the towing harness plug into the opening in the LD2
Bumper, (Fig 13). If necessary, use a flat blade screwdriver to
carefully pry the lock tab on the clip outward to help lock plug in
place.
STEP 5
5/6
Customer Support: www.TygerAuto.com/Contact
Insert the (2) push-in plugs to attach the license plate to the
Bumper, (Fig 13). Insert the License Plate Light into the mounting
hole. Use the included Wire Ties to attach the factory wiring
harness to the Bumper and away from exhaust.
STEP 6
With assistance, position the Bumper up to the bumper brackets
on the ends of the frame. Temporarily support the weight of the
Bumper Assembly.
WARNING:
To avoid possible injury or damage to the vehicle, do
not proceed until the Bumper is fully and safely supported.
STEP 7
WARNING!
DO NOT crawl under bumper unless the bumper is
properly supported on blocks or stands or the bumper may fall.
(Fig 12) Remove Fill Panel to Install
Outer Lights If Desired (not included)
Rear
(Fig 13) Install trailer plug, License Plate Light,
License Plate Plugs and Hitch Cover as required
Hitch Cover
(2) Plastic Plugs
License Plate Light
