4/6
Customer Support: www.TygerAuto.com/Contact
IMPORTANT:
Sensors fit snug in sockets. The 4mm Screws are
used to apply slight pressure to lock the sensors in place. Tighten
both screws evenly until they touch the sensor body only. DO NOT
overtighten screws or damage to sensors will result
b. Remove the outer plastic sleeve from the sensor, (Fig 9)
e. Repeat previous Steps to install remaining sensors.
f. Attach factory wiring harness to sensors.
NOTE:
Use the included (2) Wiring Harness Extensions as
necessary to extend the factory harness to reach the sensors
through openings in the Bumper.
g. Optional:
Secure each sensor to the socket with (2) 4mm x
10mm Button Head Screws, (Fig 7).
d. Insert sensor with Seal into sensor mount, (Fig 11). Push
Sensor Retaining Clip into sensor mount and lock into mounting
holes, (Fig 11).
c. Next, remove the silicone seal from the end of the sensor. Slide
the included larger Foam Sensor Seal over front of sensor, (Fig
10).
(Fig 9) Remove the Sleeve (Right) From Each Sensor
(Fig 10) Replace Seal On Sensor with Foam Seal
(Fig 11) Push Sensor Into Sensor
Sleeve On the Back of The Bumper
Sensor Seal
Retaining Clip
