2/6
Customer Support: www.TygerAuto.com/Contact
Start installation by unplugging all wiring harnesses leading to
the bumper, (Figs 1 & 2). Move the wiring harnesses away from
the bumper.
STEP 1
Remove the license plate. Place blocks or jack stands under the
bumper to support it during bumper bolt removal. Once the
bumper has been safely supported, remove the (2) hex bolts
behind the license plate, (Fig 3). Next, remove the (4) factory
bumper bolts, (2 per side), and slide the rear bumper off of the
end of the frame, (Figs 4 & 5).
IMPORTANT:
Assistance is required to hold the bumper in place
during hardware removal and to prevent the bumper from falling.
Move the bumper to a clean stable work surface.
WARNING!
DO NOT remove bumper bolts unless the bumper is
properly supported on blocks or stands or the bumper may fall.
STEP 2
PROCEDURE:
READ INSTRUCTIONS CAREFULLY BEFORE STARTING
INSTALLATION. ASSISTANCE IS HIGHLY RECOMMENDED TO AVOID
POSSIBLE INJURY OR DAMAGE TO THE VEHICLE. ALLOW EXHAUST
TO COMPLETELY COOL BEFORE STARTING INSTALLATION.
(Fig 3) Remove License Plate and (2) Hex Bolts
(Fig 4) Example of Factory Bumper Bracket with
(2) Hex Bolts pictured from Behind Bumper
Factory bumper bolts
Rear
(Fig 1) Unplug License Plate Lights
Wiring Harness
Rear
(Fig 2) Unplug Trailer Connector
