KANGAROO
e
Pump
™
Enteral Feeding Pump
figure a.
RUNNING
mode screen
for continuous feed mode.
figure . Program locked screen,
which indicates the pump is in loCK
seTTInGs mode.
KTo
(Not Available in EZMODE)
The Keep Tube Open
(KTo)
function within the KANGAROO ePump enteral feeding pump will help prevent a blockage of the
feeding set by moving the feeding solution periodically within the tube. On regular intervals, calculated from the pump’s presently
programmed feed rate, a small and clinically insignificant portion of feeding solution is moved through the tube. The amount of
delivered fluid is monitored, tracked, and calculated into the final feed volume totalizer amounts displayed to the user. The
KTo
feature can be activated via the
RUnnInG
screen. To activate the
KTo
feature, press the input button to the left of the
KTo
icon, see
Figure 15A, to immediately input a desired time in minutes for which the pump will remain in the “Keep Tube Open” mode before
resuming the previously programmed feeding regimen. Each press of the input button will increment the
KTo
time by 5-minute
increments, up to 30 minutes, see Figure 15B. After “30” is reached, each additional button press will increment in larger time steps,
up to a maximum of 240 minutes. Another button push after 240 will cycle the
KTo
back to 5 minutes. No other input is needed to
start the countdown, as the time immediately counts down after the incremental value is reached.
lock screen feature
(Not Available in EZMODE)
The KANGAROO ePump enteral feeding pump can be set to
RUn
and then locked out from unauthorized use. While the
loCK
seTTInGs
feature prevents only changes to the input parameters, the
loCK sCReen
feature will lock out any button presses,
including
RUn
or
HolD
, except power off.
Use
loCK sCReen
when the pump is running and there is a need to prevent tampering such as putting the pump into an unwanted
HolD
. The
RUnnInG
screen will show a padlock to indicate that no changes can be made without unlocking the screen.
To lock the screen, use the following procedure while the pump is in
RUNNING
mode:
• Press and hold the third
4
button from the top for at least 3 seconds, and then release it.
To unlock the screen, use the same procedure above.
figure . Padlock
indicates pump is in
loCK sCReen mode.
figure b. KTo.
