Illustra Pro Series 5MP, 3MP & 2MP Mini Dome Series
9
4. Mount the Camera Enclosure
Select the type of mounting required and refer to the relevant procedure:
Flush Mount Using Screws (Indoor)
Surface Mount (Indoor)
Surface Mount (Outdoor)
Mount Using a Junction Box (Indoor)
Mount Using a Junction Box (Outdoor)
NOTE:
If the camera is being wall mounted, after hardware installation ensure that the mirror and flip option is
enabled using the camera GUI. Refer to Enable correct Video Orientation for a Wall Mounted
Camera.
Flush Mount Using Screws (Indoor)
1. For a plenum rated ceiling, feed the leads through the plenum cover, then connect the wiring
and assemble the plenum cover. Secure with two M3 screws to the camera assembly.
2. Insert the camera assembly into the ceiling; fasten the two TP4 screws to the inserted
anchors to secure the camera assembly in place.
3. Aim the camera to the area of interest by rotating and panning the camera base. When
rotating the camera base, do not rotate it past the stop point. When desired orientation is
achieved tighten the two pivot screws to secure.
4. Fit the camera liner over the camera assembly so that it snaps into place.
5. Use the supplied security torx key to tighten the three cover screws to secure the bubble
assembly.
6. Finally, insert the screw hole covers to cover three screws in the bubble assembly.
