Tyco Fire Protection Products AutoPulse Z-20, Руководство по установке

Страница: 10 / 12

10
Mounting
Instructions 1. Using the four provided screws, mount the annunciator in its back box (see Figure 6 for semi-
flush mounting and Figure 7 for surface mounting).
2. Label the separate user-defined labels with the appropriate label, based on programming.
3. Carefully pull the top of the label pocket forward and insert the user-defined labels.
4. Gently push on the trim plate to snap it in place, over the annunciator.
Figure 6. Semi-flush mounting for retrofit installation
Figure 7. Surface mounting
Verification
Procedure When the installation is complete, verify that the remote annunciator is working properly.
If the annunciator displays the message
Error communicating with Master, or if the
annunciator fails to power, check the wiring. If the wiring is correct, call technical support. If the
annunciator is not wired properly and is not communicating with the AUTOPULSE Z-20, error
messages appear and an audible signal is emitted. Also, a card missing trouble displays at the
AUTOPULSE Z-20.
For programming changes, please refer to the
Programmer’s Manual , 579-1167AR.
#8-32
screws
Trim plate
LCD
annunciator
Bracket
Keyswitch
User-defined
labels
6-gang box or
Mansonry box
#8-32
screws
Trim plate
LCD
annunciator
Box
User-defined
labels
Keyswitch
Color Touchscreen LCD Annunciator Installation Instructions, Continued