20
6.3 To remove push the two snapfits at S2 UMS-profile and slide the
wraparound plate towards S1 UMS-profile.
6.1
Remove the VELCRO and routing block cap. To remove the
routing block cap lift the two snaps at one side of the routing block cap.
6.2
Fix the wraparound groove plate on the UMS by putting the
plate with the long protrusions in the S1 UMS-profile and sliding the
plate in the S2 UMS-profile until it snaps. (Do not leave gaps between
groove plates).
6.4
Place a tray in the wraparound groove plate; do this by pushing
the lip on the groove plate (lowest possible position) slightly down with
the tray and move the tray lateral into the hinge-cavities of the groove
plate. To snap the High Capacity Single Element tray (HCSE) in the W/a
single fiber groove plate leave always one hinge facility open between
Fasblock or previous tray and the HCSE-tray.
16 PORT BASE
: Ports (1+3+5+11+13), (2+4+6+12+14) for cables to
(S2). Ports (5+7+9+15+17), (6+8+10+16+18) for cables to (S1). Verify
the position of two cables if they are placed on the same side (next to
each other) because the total amount of loose tubes in ports going to
one tubeholder can never be more than mentioned in the capacity of
the tubeholder.
S1
S2
