409-5880
Programmer Kit 356484-1 for FFC Terminating Machines 224910-[ ] and 318619-[ ]
Rev B
3 of 13
Tyco Electronics Corporation
Figure 1
Specifications
Dimensions (Approximate)
Length:
438.15 mm [17.25 in.]
. . . . . . .
Width:
285.75 mm [11.25 in.]
. . . . . . . .
Height:
332.40 mm [6.00 in.]
. . . . . . .
Weight (Approximate)
9.55 kg [21 lbs]
Control Module
1. INTRODUCTION
Programmer Kit 356484–1 consists of Control Module 1213035–1 and the associated hardware. The
programmer kit is a user–programmable controller which is included with Flexible Flat Cable (FFC) Terminating
Machine 318619–[ ] and can be used with FFC Terminating Machine 224910–[ ]. The programmer kit provides
the ability to skip cable positions while terminating flexible flat cable with the FFC terminating machine.
The control module must be located adjacent to the FFC terminating machine within easy reach of the
operator. The control module, which is connected to the machine by a cable assembly, requires a 120 Vac,
50/60 Hz, single–phase power supply. Specifications for the control module are listed in Figure 1.
When reading this manual, pay particular attention to DANGER, CAUTION, NOTE statements.
Denotes an imminent hazard which may result in moderate or severe injury.
Denotes a condition which may result in product or equipment damage.
Highlights special or important information.
This manual covers basic description of the control module, information on the sequence of operations,
installation of the programmer kit to the FFC terminating machine, programmer kit and machine adjustments,
and programmer error conditions.
DANGER
CAUTION
!
NOTE
i
