19
http://www.TYAN.com
2.17 – Installing the Power Supply
There are two power connectors on your Trinity i845GL. By default, the Trinity i845GL requires
that you have an ATX12V power supply that has a 20-pin and a 4-pin power connector. Do not
use any other type of power supply.
1.
Disconnect power supply from electrical outlet
2.
Connect ATX12V 4-pin power connector
3.
Connect ATX12V 20-pin power connector
4.
Connect power cable to power supply to power outlet
Make sure you have connected BOTH the 20-pin and 4-pin connectors before attempting to
apply power to the board.
2.18 – Finishing Up
Congratulations on making it this far! You’re finished setting up the hardware aspect of your
computer. Before closing up your chassis, make sure that all cables and wires are connected
properly, especially IDE cables and most importantly, jumpers. You may have difficulty powering
on your system if the motherboard jumpers are not set correctly.
In the rare circumstance that you have experienced difficulty, even though the instructions herein
were followed, you can find help by asking your vendor for assistance. If they are not available for
assistance, please find setup information and documentation online at our website or by
calling
your vendor’s support line.
