TX RX Systems 434B-83H-01-M-110/48, Инструкция по установке и эксплуатации

Страница: 35 / 44

7;5;6\VWHPV,QF Manual 7-9547-1 12/09/14 Page 35
modified by clicking in the associated box and
entering the new value.
The DHCP (Dynamic Host Configuration Protocol)
is either active or inactive. When DHCP is active
the values for IP address, netmask, and gateway
are set to zero. When DHCP is inactive (default
setting from the factory) the IP address, netmask,
and gateway values can be modified by the user by
typing the desired values into the associated box
and pressing the submit button.
SNMP Configuration
The SNMP Configuration menu without password
access displays the three IP addresses that trap
messages will be sent to as well as the SNMP ver-
sion (refer to
Figure 25
). With password access
the screen will now display the three destination IP
addresses, authentication type, user name (this
field must have a value or traps will not be sent), a
password for the user name, encryption type, and
an encryption passphrase. The SNMP Configura-
tion screen with password access is shown in
Fig-
ure 26
.
The destination IP addresses should be the IP
addresses of the computers you want the traps to
be sent to. The destination computer must have
trap receiver software installed and running. The
trap receiver software is available for download.
Authentication type can be either none or MD5.
The User Name field must have a value entered
with the associated user name password optional.
Encryption type can be either none or MD5 with
the associated encryption passphrase as optional.
Whenever values in the SNMP Configuration
screen are changed you must click on the submit
button to save the changes.
Figure 23:
Network Configuration menu without password access.
Figure 24:
Network Configuration menu with password access.