5. CLEANING AND MAINTENANCE OPERATIONS
5.1. GENERALITIES AND PRODUCTS FOR CLEANING
BEFORE CARRYING OUT ANY CLEANING OR MAINTENANCE OPERATIONS, CHECK
TO MAKE SURE THAT THE MAINS SWITCH BE OFF AND THE SUPPLY PLUG
DISCONNECTED FROM THE MAINS.
ACCURATELY CLEAN THE EQUIPMENT AND THE DISCS EVERY DAY FOR A CORRECT
OPERATION AND LIFE OF THE EQUIPMENT.
THE DISCS, THE GRID FOR CUTTING DICES, AND THE PLASTIC EJECTOR, CAN BE
REMOVED FOR WASHING UNDER A WARM WATER JET.
CLEAN THE MACHINE, AND ABOVE ALL WHERE THE DISCS REST, WITH A CLOTH
OR A SPONGE WET WITH WARM WATER, ACCURATELY REMOVE ALL WASTES TO
PREVENT THE DISCS FROM CHANGING THEIR POSITION.
OPEN THE COVER AND LOOSEN THE 1 PIN AS SHOWN IN FIG.3. REMOVE THE COVER
AND WASH UNDER A WATER JET.
(3)
CLEAN THE SURFACES WITH WATER AND SOUP, ALCOHOL, DETERGENTS WITHOUT
ABRASIVES OR SUBSTANCES BASED ON CHLORINE OR SODA (CHLORINE WATER,
MURIATIC ACID).
NEVER USE ABRASIVES, STEEL WOOL, OR SIMILAR PRODUCTS AS THEY MAY
BRING DAMAGES TO THE PAINT, THE COAT, OT THE MACHINE BODY.
FOR CLEANING, USE NON-TOXIC PRODUCTS AND ONES THAT GUARANTEE THE
BEST HYGIENE.
5.2. OPERATIONS IN THE CASE OF FAILURES
WHEN THE WHITE POLIT LIGHT ON THE PANEL IN ON, BUT THE MACHINE DOES
NOT START, CHECK TO MAKE SURE THAT THE HANDLE AND THE COVER ARE
CLOSED.
IN THIS WAY, BOTH THE SAFETY MICROSWITCHES.
THE SAFETY
MICROSWITCHES PREVENT THE MACHINE START WHENEVER ALL SECURITIES ARE
NOT ACTIVATED.
IN THE CASE OF FAILURES, DISCONNECT THE MAIN WALL SWITCH AND EITHER
WARN THE MAINTENANCE SERVICE, OR THE SKILLED PERSONNEL.
NEITHER START NOR TAMPER WITH THE EQUIPMENT PERSONALLY.
