Twose TE480, Руководство оператора

Страница: 28 / 50

17
ATTACHING THE MACHINE – Link Type Stabilizer
IMPORTANT: -
Attachment of the machine to the tractor should always be performed on a firm level site.

Remove locking pins and lift pins supplied with Hedge trimmer from lower link
positions of linkage frame.

Slowly and very carefully reverse the tractor towards the machine linkage frame.

With care - ensure that tractor lower link ball eyes fit between lower jaws of linkage
frame and that pin holes are aligned.
SWITCH OFF TRACTOR ENGINE AND ENSURE HANDBRAKE IS ON

With holes of tractor lower link eyes in line with lower jaw holes of frame - the lower
linkage pins should now be refitted –
fit spacers if required to prevent side movement
of link arms.

Secure lift pins in position using locking pins.

Fit and secure the stabiliser’s top link yoke to the tractor’s top link - select the highest
available position avoiding any load sensing properties.

Attach top link to machines top link point.

Raise the machine on the tractor’s linkage to a position where the stub shaft of the
tractors PTO drive and the stub shaft of the machine gearbox are horizontally aligned.
Note: As lift occurs be aware that the machine may tilt slightly.

Tractor lower linkage check chains should now be tightened to ensure tractor arms are
locked and machine is positioned centrally to the tractor.

Adjust top link to bring the machine into the vertical position.

Check the PTO shaft length.
When connected from tractor to machine it should engage by 1/3rd of the total shaft
length, i.e. male part should be halfway from the end to fully ‘bottomed’ out. Do not
use the machine until this has been cut to the correct length.
Measure the PTO shaft and cut to the dimension
shown – the finished length of the PTO shaft
should be 75mm (3”) less than the measured
distance ‘
A ’ -between tractor shaft and gearbox
stub shaft – to enable fitting.
NOTE:
For subsequent use with different tractors measure
again, there must be a minimum shaft overlap of
150mm (6”).