www.tsicustomerservice.com
A385
6
COOL DOWN CYCLE
NIGHT MODE
After the heater has ran the fan will continue to run for a period
of time to cool down the internal parts.
Toggle between night mode which reduces the halogen and
reduces the brightness of the heater for night use.
“ ” display show when turn off the halogen.
This product is equipped with a safer Plug; an advanced safety
device that helps detect electrical fires caused from faulty outlets.
Overloading of outlet, adapters and surge protectors may cause
overheating, damage, and increase risk of fires. Safer Plug
continuously monitors the temperature in the plug and outlet
and will turn off the heater to prevent unsafe outlet overheating.
If the Safer Plug cuts the power due to unsafe conditions it will
show an “ ”message on the screen. If this occurs the Safer
Plug has prevented a potentially unsafe condition.
To reset the device if this occurs, first allow the plug to cool down.
Once the plug has cooled down, unplug the device and wait
5 seconds, then plug back in and continue to use normally.
If the Safer Plug continues to activate your outlet may be faulty.
Check your heater cord and plug connections. Faulty wall outlet
connections or loose plugs can cause the outlet or plug to
overheat. Be sure the plug fits tight in the outlet. Heaters draw
more current than small appliances, overheating of the outlet may
occur even if it has not occurred with the use of other appliances.
During use check frequently to determine if your plug outlet or
faceplate is HOT! If so, discontinue use of the heater and have a
qualified electrician check and/or replace the faulty outlet(s).
SAFER PLUG
SAFER SENSOR
OPERATION INSTRUCTIONS
FUNCTION
ICON
DESCRIPTION
Patent Pending
Patent Pending
This product is equipped with a Safer Sensor; an advanced safety
device that helps prevent heaters from being accidently covered or
blocked causing a potentially unsafe condition.
The SAFER SENSOR detects if an object is too close to the front
of the heater potentially obstructing the air outlet. If blocked, the
SAFER SENSOR icon on the control panel will flash, the heater
will beep continuously, and then shut off. Once the object has
been moved, the icon will stop flashing, the beeping will cease,
and the heater will turn back on.
To disable the Proximity Sensor safety function press and hold
the ECO MODE button for 10 seconds. Once disabled the SAFER
SENSOR icon will remain lit indicating it is disabled. Repeat this
step to re-enable the function.
