10
OPERATING INSTRUCTIONS
INITIAL START UP:
1.
Before you start your heater examine the heater installation to determine that:
•
Areas immediately around heater including the air inlet and flue areas are free from obstructions.
•
Physical support of the heater is safe, secure, adequate and sound.
•
There is no obvious deterioration of the heater, gas inlet hose and AC adapter if used.
2.
REMOTE CONTROL SYNCRONIZATION & START-UP TEST:
•
The remote control leaves the factory already synchronized for each heater. To verify that, with the
heater’s gas inlet valve in the CLOSED position, verify that the remote control system is working
properly.
•
Push the “ON” button on the remote control. You will hear a continuous spark sound at the pilot. If
there are no sparks, replace the AA batteries with new ones. If with the new batteries there are still
no sparks, synchronization is needed. For synchronization perform the following steps.
Single heater application
a)
Push-and-hold the “LEARN” button on the module for 2 seconds
until it “beeps”.
NOTE:
Holding for 10 seconds will clear the
module.
b)
Push-and-hold the ON button on the remote and the “beep” sound
will confirm synchronization.
NOTE:
Holding for 10 seconds will
clear the module.
Multiple heater application
a)
Push-and-hold the “LEARN” button on the module for 2 seconds until it “beeps” and then remove a
battery. Repeat same step for all heaters.
b)
Install the battery only to one heater.
c)
Push-and-hold the “LEARN” button until it “beeps” once and then push-and-hold the ON button on
a remote control and the next “beep” sound will confirm synchronization.
NOTE
: One remote control per heater.
d)
Remove a battery to that same heater.
e)
Repeat steps b, c, d and e for the rest of the heaters and its individual remote controls.
f)
Once the synchronization is completed for all heaters place the battery back on all heaters.
3.
Check for gas leaks using soapy water at all gas connections and joint unions. NEVER use a flame to
check for leaks. (Pg 3)
4.
Pilot Burner Ignition Test
a)
Turn ON the gas supply to the heater.
b)
Please check the environment of the gas valve for a smell of gas. If for any reason you smell or
think you smell gas, see the warning in the box below
WHAT TO DO IF YOU SMELL GAS:
•
Do not try to light any appliance.
•
Do not touch any electric switch; do not use any phone in your building.
•
Immediately call your gas supplier from a neighbor’s phone. Follow the gas supplier’s
instructions.
•
If you cannot reach your gas supplier, call the fire department.
MODULE
“LEARN”
