TW Gema OptiSelect, Инструкция по эксплуатации и каталог запасных частей

Страница: 30 / 49

V 07/07
28
•
Maintenance and cleaning OptiSelect manual powder gun
5. Clean the integrated gun tube with the supplied brush, if neces-
sary
6. Blow through the gun again with compressed air
7. Clean the powder hose
8. Reassemble the gun and connect it
Attention:
Cleaning the OptiSelect manual powder gun with the following sol-
vents is not allowed:
Ethylene chloride, acetone, ethyl acetate, methyl ethyl ketone, me-
thylene chloride, premium gasoline, turpentine, tetrachloromethane,
toluene, trichloroethylene, xylene!
Note:
Only cleaning agents with a flash point of a least 5 Kelvin above the
ambient temperature, or cleaning places with technical ventilation
are allowed!
Cleaning the spray nozzles
Daily or after every shift
-
Clean the inside and outside of the spray nozzle with
compressed air.
Never immerse the parts in solvents!
-
Check the seating of the spray nozzles.
Make sure that the threaded sleeve is always tightened
well. If the spray nozzle is not completely tight, the dan-
ger exists, that the high voltage of the gun can flash
over, which can lead to damage to the powder gun!
Weekly
-
Remove the spray nozzles and clean inside with com-
pressed air. If sintering should have formed, then this is
to be removed!
Monthly
-
Check the spray nozzles for wear
The flat jet nozzle is to be replaced, if:
-
the spray pattern is no longer a regular oval
-
deeper grooves in the nozzle slot or even the wall thick-
ness is no longer visible
-
the wedge of the electrode holder is worn down
Nozzles with deflectors:
-
if the wedge of the electrode holder is worn down, then
the electrode holder is to be replaced