8
EASY 1-MT
Issued 05/00
C) POWDER COATING
Make sure that all electrically conductive parts within 5 m of the
coating booth are grounded!
1. Take the powder gun in hand and point it into the coating booth,
however, do not point it at the object to be coated yet
2. Select the application settings
Press the corresponding application key
on the control
unit. The LED of the corresponding Key illuminates.
3. Press the powder gun trigger
4. Coat the object(s)
E) SWITCHING OFF
1. Release the powder gun trigger
2. Switch off the control unit
The settings for High-voltage, rinsing air, and powder output are
retained.
F) POWDER HOSE RINSING
After longer stillstand periods the powder hose should be cleaned of
powder. Proceed as follows:
1. Remove the powder hose from the hose connection on the
injector
2. Point the powder gun into the booth
3. Blow the hoses through manually with a compressed air gun
4. Replace the powder hose on the hose connection of the injector
again.
7. Adjust the powder cloud to a test object
When using flat jet nozzles:
- Unscrew the threaded sleeve approximately 45
°
, so that the flat
jet nozzle (or extension) can be turned slightly
- Turn the flat jet nozzle to the desired axial position
- Tighten the threaded sleeve again
When using round jet nozzles with air rinsed deflector plates
- Exchange the deflector plate (ø 16, 24, and 32 mm supplied with the
powder gun)
Attention: The deflector plates are pushed on and must not
be turned!
D) REMOTE CONTROL THROUGH THE POWDER GUN
With the aid of the Keys
+
and
–
␣ on the rear of the powder gun differ-
ent functions can be remotely controlled:
1. Select the application settings
Press the Keys
+
and
–
on the powder gun
simultaneously
Check by observing the LED display on the powder gun:
Red = Flat parts
Green = Complicated parts
Red/Green (alternating) = Spraying over
2. Change the powder output
Press the Key
+
or
–
␣ on the powder gun. The powder output is
correspondingly increased or decreased.
CAUTION
