45
6. Head lamp high / low beam switch
The head lamp glows automatically once the engine
is started. Only the head lamp beam (high/low) can
be controlled with the beam control switch.
Press the top end of switch for ‘HIGH’ beam ’ ‘ and
bottom end for LOW beam ‘ ‘.
Once the engine is started the head lamp glows
automatically. Only head lamp beam (high/low) can be
controlled using beam control switch.
Head lamp intensity will reduce by 50% if the engine is
kept idle for more than 20 sec (approx).
Pass by system will not work if the engine cut off switch
is turned ‘OFF’.
Note
HANDLE BAR RIGHT SIDE
1. Electric starter switch
Ensure the transmission is in neutral or else press
the clutch lever before engaging the electric starter
switch ‘ ‘. Release the electric starter switch after
the engine has started.
If the electric starter switch is pressed more than
3 seconds continuously, the starter motor gets
disabled automatically and will not crank the
engine. The motor cranks the engine only after 3
seconds or if the switch is released and repressed
again.
1
4
3
2
Use appropriate head lamp beam ‘high / low’ as per the
traffic and road conditions for your safety and to avoid
inconvenience to other riders.
It is strongly recommended to ride the vehicle in ‘low’
beam during day.
Warning