28
Setting the digital display
Every press of the Mode button changes the display
to other mode. Follow the below procedures to
change the display to desired mode.
If ignition is turned ‘OFF’ when the meter is in ‘ODO’
or ‘TRIP’ meters, then the respective meters will be
displayed in the next ignition ‘ON’. If any other modes
other than these were set during ignition ‘OFF’, then
‘ ’ meter will be displayed in the next ignition
‘ON’.
1. In ‘ODO’ mode, press the Mode button once and
twice to enter ‘ ’ and ‘ ’ meters
respectively.
• To reset any of the trip meter while ensuring
the display is in ‘TRIP 1’ or ‘TRIP 2’, press and
hold the Set button for a few seconds.
2. In ‘TRIP 2’ meter mode, press the Mode button
once to enter lap timer mode. On entering the
lap timer mode, a message ‘ ’
and last three laps timing will be displayed in the
cluster’s display.
• To reset the timings, keep the display in
‘LAP TIMER MODE’ and wait till the cluster
displays the lap timings. Now press and hold
the Set button for a few seconds.
3. In ‘TRIP 2’ meter mode, press the Mode button
twice to enter high speed mode. On entering this
mode, a message ‘ ‘ and
last achieved high speed data will be displayed in
the cluster’s display.
• To reset the high speed recorded, keep the
display in ‘HIGH SPEED MODE’, press and
hold the Set button for few a seconds.
4. In ‘TRIP 2’ meter mode, press the Mode button
thrice to enter shortest time mode. On entering
this mode, last achieved shortest time ’ ‘ and
overall best time ‘ ‘ will be
displayed in the cluster’s display.
• To reset the last achieved shortest time, keep
the display in ‘SHORTEST TIME MODE’,
press and hold the Set button for few a
seconds. Please remember only last / current
record will be reset and best time display will
remain same until new best time is achieved.
5. Press the Mode button once to change the
display to ‘ODO’ mode again.
