TVS electronics Jus' Bill RP-35, Руководство пользователя

Страница: 31 / 42

Set item
Take-Up Device
Black Mark
Initial value
ON
DIS
Setting value
ON
OFF
DIS
TYPE1
TYPE2
Remarks
Selects the rewinder function.
During OFF, the rewinder motor does not operate.
Selects enabled (TYPE1, TYPE2)/disabled (DIS) of the
black mark control function.
In TYPE1 status, auto paper length measuring operation
is done and the black mark is fed to the paper cut
position when the power is turned on.
GS FF
GS FF GS FF
GS FF/FF
FF FF
FF commands are available in the status.
It is used for formatting the black mark at the edge of
the page.
In TYPE2 status, measuring operation is not done when
the power is turned on.
The auto paper length paper measuring, initial paper
positioning and paper cutting operations are controlled
by the command from a host PC.
FS(L
FS(L FS(L
FS(L command only is available in the status.
It is used for formatting the black mark in the middle of
the page. (TYPE2 status is not available in STAR and
CBM1/2 modes.)
Concerning Mechanical
Concerning Mechanical Concerning Mechanical
Concerning Mechanical----SW operation
SW operation SW operation
SW operation
Functions that are not supported by the specifications at time of shipping have no
impact on printer operation even when the settings are changed.
Examples Examples Examples Examples)Items set for the Auto-Cutter in models that are not equipped with an
Auto-Cutter.
Change of the setting of the Take-Up Device in models to which rewinder
specifications do not apply.
Concerning Auto
Concerning Auto Concerning Auto
Concerning Auto----Cutter operation
Cutter operation Cutter operation
Cutter operation
The minimum cutting interval is 1/2 inch (3 lines with 6LPI).
Once a cut command has been executed, even if a command is sent before the paper
has fed at least 1/2 inch, the cut command is ignored so the cut action cannot be
executed.
Initial Factory Shipping Mode Initial Factory Shipping Mode Initial Factory Shipping Mode Initial Factory Shipping Mode
Setting t Setting t Setting t Setting the mode he mode he mode he mode
1
. Pressing the FEED switch twice in
maintenance mode (POWER LED is
flashing) causes the POWER LED, PAPER
OUT LED, and the ERROR LED to begin
to flash.
Flashing
Press twice
33330000