TVS electronics Jus' Bill RP-35, Руководство пользователя

Страница: 20 / 42

Core diameter: Interior diameter

10
– 0
mm, exterior diameter

27mm or less
Chapter3
Chapter3 Chapter3
Chapter3
Preparing the Printer
Installing Roll Paper Installing Roll Paper Installing Roll Paper Installing Roll Paper
The following are the types of roll paper that can be used by this printer.
Types: 1P roll paper
2P copy roll paper (1 or 1 copy)
3P copy roll paper (1 or 2 copies)
(2P and 3P copy roll paper are only usable on models equipped with auto
cutter and rewinder.)
Paper widths: 76.2 (
±
0.7)/69.5 (
±
0.6)/57.5 (
±
0.5)mm
Roll diameter:

30mm to

83mm
+2
Paper thickness: 1P 0.06 to 0.085mm
Copy paper 0.05 to 0.20mm (total thickness)
But the total thickness that can be cut is from 0.05 to 0.14mm.
Standard and Auto Cutter Equipped Models
Standard and Auto Cutter Equipped Models Standard and Auto Cutter Equipped Models
Standard and Auto Cutter Equipped Models
Inst Inst Inst Installation method allation method allation method allation method
1
. Pull the rear cover open lever towards
you to open the rear cover.
2
. Set the attached partition in place if
Rear cover open lever
Partition
the roll paper you are using is 69.5mm
wide or 57.5mm wide.
Change the paper width by changing
the value set as the width using the
Soft SW Setting Mode.
(See page 35)
Caution Caution Caution Caution
When setting the roll paper, be
careful not to cut your
hand on the edge of
the paper.
Location set for width of 57.5mm
Location set for width of 69.5mm
19 19 19 19