Page | 19
COMMAND
DESCRIPTION
PARAMETER
LEDRED N N1
LED red backlight control
(specific)
N = BUTTON (1-15/16)
N1 = % (0-100)
N1=% (0-100)
[
LEDRED 1 50
] – Can be used to change the state of a specific red
LED. In this example the red LED on button #1 will be set to 50%
brightness.
LEDBLUES N
All blue LEDs backlight
control (common)
N = % (0-100)
[
LEDBLUES 50
] – Can be used as a common command to change the
state of all blue LEDs. In this example the blue LEDs on all buttons will
be set to 50% brightness.
LEDREDS N
All red LEDs backlight
control (common)
N = % (0-100)
[
LEDREDS 50
] – Can be used as a common command to change the
state of all red LEDs. In this example the red LEDs on all buttons will
be set to 50% brightness.
BACKLIGHT N
All LED backlight control
(common)
N = % (0-100)
[
BACKLIGHT 50
] – Can be used as a common command to change
the state of all LEDs. In this example both blue and red LEDs on all
buttons will be set to 50% brightness.
MACRO RUN N
Run a Macro (specific)
N = MACRO (1-30/32)
[
MACRO RUN 1
] – Can be used to run specific Macros. These can be
button Macros or Extended Macros. In this example the control panel
will run Macro #1. This can be useful if you want to activate a series of
Macros to run in sequence or repeat. Place [
MACRO RUN N
] at the
end of a specific command sequence.
MACRO STOP
Stop Macro (common)
NONE
[
MACRO STOP
] – Can be used as a common command to stop all
active Macros. This can be useful if a series of Macros has been
activated.
