Page | 5
3.0
Lighting column inspection
3.1
Setting up: probe zero
1
Determine and observe the electrical safety requirements of the lighting authority.
2
Open the access door on the column.
3
Visually confirm the state of the column at a level about 150mm (6 inches) above
ground level.
4
Place the coil system of the ColcheK
2™ around the base of the column.
5
Switch the unit on using the main switch and wake the unit up using the “on” control
on the display module. The following screens will be seen.
6.
Push the probe down the inside of the column, against the wall, until the tip of the
probe is just below level with the top coil. See Fig. 1 below. It does not matter where
the probe is placed round the circumference of the column.
