Tuxedo MR6K-38, Руководство по эксплуатации

Страница: 15 / 29

3. Lubricate the sliding pieces with heavy duty bearing grease.
4. Final Adjustment.
A. If any problems are encountered, do not proceed with subsequent steps. Instead,
resolve the problem before proceeding by referencing the troubleshooting portion of
the Owner’s Manual section of this manual.
B. Raise the lift to full height. Lower the lift onto the safety latches. Raise the platforms,
pull out both latch pull rods, and lower the lift to the ground.
C. Raise the lift empty to the top of its travel and lower it to the floor three (3) times to
remove the remaining air from the hydraulic system.
D. The latches should click together as the lift is being raised.
E. When the platforms are lowered onto the locks, neither pull rod should be capable
of being pulled out.
F. The first time a vehicle is placed on the lift, raise it no higher than 500 mm.
Lower the vehicle onto the safety latches. Raise the lift higher (about 200 mm)
and open both latch pull rods then lower the vehicle to the floor.
G. Raise the vehicle to full height and lower the platforms onto the safety latches. Lower
the vehicle to the floor.
H. After cycling the lift ten times with a vehicle on it, recheck the tightness of the
screws in the basement.
3.4. Preparation for Starting up
3.5.1. The latch is engaged when installed in the column.
3.5.2. The hydraulic oil should be ISO-22.
3.5.3. Have a
certified
electrician establish
a
110V/60Hz/20A power supply to motor
and overheated switch. A protection against indirect contact (RCCB) need
s
to be
provided by the user
3.5.4. Air Evacuation. There may remain little air in the hose or cylinder during
installation. Operating the lift up and down in the working height several times
without load.
- - 11