Tuthill 6000, Инструкция по установке и обслуживанию, Страница: 23 / 36

Service Manual # 67
Page 23 of 36
15. Place the adapter plate on the motor register.
16. Place the motor on a flat surface with the shaft facing upward.
17. Place the key into motor shaft keyway.
18. Carefully lower outer magnet onto shaft until inside face of outer magnet is flush with the shaft.
(see Figure 2).
19. Lock outer magnet onto shaft with set screws, installing the cone-pointed set screw first.
! CAUTION
DO NOT PLACE HAND OR FINGERS BETWEEN THE BRACKET AND ADAPTER. The magnets
are extremely strong and will attract all metallic objects and can be the source of pinch points. Do
not wear watches or other metallic jewelry when working with magnets. See warning on page 2.
Use jack screws to assemble models 6210 Series pumps. Jack screw kits are available as part
number 2CMG 558 for models 6212, 6213 and 6214 and part number 5CMG 558 for models 6215
and 6216.
Failure to follow proper procedures or use appropriate tools could result in injury to you or damage
to either personal property or the pump.
20. Install pump head to motor. Use jack screws to control the attraction of the inner and outer
magnets:
a. Place (3) guide studs into adapter through the bracket screw clearance holes and hand-
tighten.
b. Screw (1) jack screw into bearing housing until it extends to the end of the outer magnet.
c. Slowly unscrew jack screw from bearing housing. This will lower sub-assembly into
adapter register.
d. After magnet bearing housing sub-assembly has been lowered into place, remove guide
studs and jack screw.
21. Secure pump head into place with screws.